Mapping natural forest stands with low cost drones
Palabras clave:
Structure from Motion, tree delineation, plot inventory, longleaf pine, southeast USResumen
We used a low-cost hobby drone to produce high resolution aerial photographs of a 12 ha mature longleaf pine (Pinus palustris) stand. The photos were combined into orthophoto mosaics and digital surface models to produce repeatable crown maps. Repeated flights allowed the use of tree phenology to separate longleaf from loblolly (Pinus taeda) and pond (Pinus serotina) pines, as well as some hardwood species. Careful ground control was necessary to produce aerial crown maps that matched field measured stems. However, average crown area/stem basal area ratio of 15 m radius plots produced correlation coefficients comparable to open single tree measures, ground control improved the relationship especially for loblolly and pond pine. With ground control height measurement was comparable to SfM (Surface from Motion) research results but had a positive bias greater than 1 m. The most difficult problem was determining individual trees associated with a mapped crown area. Height measures were hampered by our inability to determine a correction for the true ellipsoid height of the camera.
Referencias
Agisoft. 2019. Agisoft Metashape. St. Petersburg: Russia. Agisoft LLC.
Bechtold, W.A., and P.L. Patterson (eds.). 2005. The enhanced forest inventory and analysis program - national sampling design and estimation procedures. General Technical Report SRS-80. Asheville, NC: U.S. Department of Agriculture, Forest Service, Southern Research Station.
Csillik, O., J. Cherbini, R. Johnson, A. Lyons, and M. Kelly. 2018. Identification of citrus trees from unmanned aerial vehicle imagery using convolutional neural networks. Drones. 2: Article 39.
Dabberdt, W.F., D.H. Lenschow, T.W. Horst, P.R. Zimmerman, S.P. Oncley, and A.C. Delany. 1993. Atmosphere-surface exchange measurements. Science. 260: 1472-1481.
dos Santos, A.A., J.M. Junior, M.S. Araújo, D.R. Di Martini, E.C. Tetila, H.L. Siqueira, C. Aoki, A. Eltner, E.T. Matsubara, H. Pistori, and R.Q. 2019. Assessment of CNN-based methods for individual tree detection on images captured by RGB cameras attached to UAVs. Sensors. 19: Article 3595.
Guerra-Hernández J., E. González-Ferriro, V.J. Monleón, S.P. Faias, M. Tomé, and R.A. Diaz-Varela. 2017. Use of multi-temporal UAV-derived imagery for estimating individual tree growth in Pinus pinea stands. Forests. 8: Article 300.
Litchi. 2018. Litchi for DJI Mavic / Phantom / Inspitre / Spark. Brooksville, FL: VC Technology, Inc.
Novick, K.A., J.A. Biederman, A.R. Desai, M.E. Litvak, D.J.P. Moore, R.L. Scott, and M.S. Torn. 2018. The Ameriflux network: A collaboration of the willing. Agricultural and Forest Meteorology. 249: 444-456.
Onishi, M., and T. Ise. 2018. Automatic classification of trees using a UAV onboard camera and deep learning. arXiv: 1804.10390.
Salach A., K. Bakuła, M. Pilarska, W. Ostrowski, K. Górski, and Z. Kurczyński. 2018. Accuracy assessment of point clouds from LiDAR and dense image matching acquired using the UAV platform for DTM creation. ISPRS International Journal of GEO-Information. 7: Article 342.
Wallace L., A. Lucieer, Z. Malenovský, D. Turner, and P. Vopěnka. 2016. Assessment of forest structure using two UAV techniques: A comparison of airborne laser scanning and structure from motion (SfM) point clouds. Forests. 7: Article 62.
Wang, Y., H. Weinacker, B. Koch, and K. Stereńczak. 2008. LiDAR point cloud based fully automatic 3D single tree modelling in forest and evaluations of the procedure. The International Archives of the Photogrammetry, Remote Sensing and Spatial Information Sciences. XXXVII(Part B6b): 45-51.
Williams B.J., Williams T.M. O’Halloran T.L., and Song B. 2018. Comparison of low cost UAVs to accurately measure tree size and location. P 47-58 In Merry K, Bettinger P., Cieszewski C, Crosby M, Lowe R, Siry J. Proceedings 11th Southern Forestry and Natural Resource Management GIS Conference . University of Georgia, Athens GA, Dec 11-12, 2017
Descargas
Publicado
Número
Sección
Licencia
Authors who publish with this journal agree to the following terms:- Authors grant the journal right of first publication, with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) following the publication by the journal, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).
